Dell Precision M2400 (Mid 2008) - Manual (Page 27)

The table below shows a basic field settings example for the Intel AMT Configuration menu page to configure the computer
in static mode. The computer requires two MAC addresses (GBE MAC address and Manageability MAC Address) to operate in
static mode. If there is no Manageability MAC address, Intel AMT cannot be set in static mode.
Intel AMT Configurations Example in Static Mode
Intel AMT Configuration Parameters Values
Intel AMT Configuration Select and press
Host Name Example: IntelAMT
TCP/IP
Set the parameters as follows:
Enable Network interface
Disable DHCP Mode
Set an IP address (e.g., 192.168.0.15)
Set a subnet mask (e.g., 255.255.255.0)
The default gateway address is optional
The preferred DNS address is optional
The Alternate DNS address is optional
Set the domain name (e.g., amt.intel.com)
Provision Model
Intel AMT 4.0 Mode
Small Business
SOL/IDE-R
Enable SOL
Enable IDE-R
Remote FW Update Enabled
Save and exit MEBx and then boot computer to the Windows operating system.
* Information on this page provided by Intel .
Back to Contents Page