Dell P2714H Monitor - Manual (Page 56)

56

Troubleshooting
Product-Specific Problems
Specific Symptoms What You
Experience
Possible Solutions
Screen image is too
small Image is centered on
screen, but does not
fill entire viewing area • Reset the monitor to Factory
Settings.
Cannot adjust the
monitor with the
buttons on the front
panel OSD does not appear
on the screen • Turn off the monitor, unplug
the power cord, plug back, and
then turn on the monitor.
No Input Signal when No picture, the LED • Check the signal source. Ensure
user controls are
pressed light is white. When
you press “up”, “down”
or “Menu” key, the
message “ No input
signal” will appear.
the computer is not in the
power saving mode by moving
the mouse or pressing any key
on the keyboard.
• Check whether the signal cable
is plugged in properly. Re-plug
the signal cable if necessary.
• Reset the computer or video
player.
The picture does not The picture cannot fill • Due to different video formats
fill the entire screen the height or width of
the screen
(aspect ratio) of DVDs, the
monitor may display in full
screen.
• The option you select in Display
Settings-Aspect Ratio might
also influence the picture fitting
on screen.
• Run the built-in diagnostics.
NOTE: When choosing DVI-D or DP mode, the Auto Adjust function is
not available.