Dell P2714H Monitor - Manual (Page 51)

Dell P2714H
The dispaly will go into Power Save Mode in 5 minutes
No VGA Cable ?
4. This box also appears during normal system operation, if the video
cable becomes disconnected or damaged. The monitor will enter
Power Save Mode after 5 minutes if left at this state.
5. Turn off your monitor and reconnect the video cable; then turn on
both your computer and the monitor.
If your monitor screen remains blank after you use the previous
procedure, check your video controller and computer, because your
monitor is functioning properly.
NOTE: Self-test feature check is not available for S-Video, Composite,
and Component video modes.
Built-in Diagnostics
Your monitor has a built-in diagnostic tool that helps you determine if the
screen abnormality you are experiencing is an inherent problem with your
monitor, or with your computer and video card.
5
4
3
2
1
NOTE: You can run the built-in diagnostics only when the video cable
is unplugged and the monitor is in self-test mode.
Troubleshooting

51