5 port commands, 1 show port link, Port commands 3.5.1 show port link – Dell POWEREDGE M1000E User Manual
Page 15
Rev 1.00
15
3.5
Port Commands
3.5.1 show port link
Synopsys:
show port link [port_number]
Description:
This command displays detailed port information. If an uplink port number is specified
([port_number]), then the command displays information only for this port; otherwise, the com-
mand displays information for all the ports.
The command displays the following information per port:
• Port number
• Port group identifier and speed: A, B, followed by the configured speed (10G)
• Pass through connection status, may have one of the following values:
down - either uplink or downlink is not connected
mismatch - both uplink and downlink are connected, but there is a mismatch
10G - uplink and downlink are connected at 10GbE
• Downlink port link state:
- down: blade not present
- 10G: 10GbE link
• Uplink port link state:
- empty: No module present
- module_type [no link]: Module is present (module type is shown);
no link: optical fiber cable is disconnected
Example:
# show port link
Port
Group
Connect
Downlink
Uplink
Status
--------------------------------------------------------------
1
A (10G)
10G
10G
SFP+ SR
Link Up
2
A (10G)
10G
10G
SFP+ SR
Link Up
3
A (10G)
10G
10G
SFP+ LR
Link Up
4
A (10G)
10G
10G
SFP+ SR
Link Up
5
A (10G)
10G
10G
SFP+ SR
Link Up
6
A (10G)
mismatch
10G
SFP SX
Link Down
7
A (10G)
down
down
SFP+ SR
Link Down
8
A (10G)
down
down
empty
9
B (10G)
mismatch
10G
SFP SX
Link Down
10
B (10G)
mismatch
10G
SFP SX
Link Down
11
B (10G)
mismatch
10G
SFP SX
Link Down
12
B (10G)
mismatch
10G
SFP LX
Link Down
13
B (10G)
down
down
empty
14
B (10G)
down
10G
SFP+ SR
Link Down
15
B (10G)
mismatch
1G
SFP+ SR
Link Down
16
B (10G)
mismatch
1G
SFP+ SR
Link Down