Cabletron Systems FOT-F3 - Manual (Page 28)

CHAPTER 3: INSTALLATION
3-8 FOT-F3 USER’S MANUAL
If a link is not established, contact Cabletron Systems Technical
Support. Refer to Chapter 1, Getting Help, for instructions.
3.3 SURFACE MOUNTING THE FOT-F3
Using the contents of the accessory package, you can mount the
FOT-F3 on a surface close to the workstation or on the
workstation itself.
The surface you choose should meet the following
requirements:
• Allows the fiber optic segment to be easily connected to the
transceiver.
• Allows the AUI cable to be easily connected from the
transceiver to the workstation.
• Has a smooth, dirt-free surface which accepts the adhesive
bonds.
Mount the FOT-F3 as follows:
1. Separate the two 1.5-inch x 3-inch Velcro mounts.
2. Peel off the paper that covers the adhesive backing of one
Velcro mount.
3. Carefully position the Velcro on the back of the FOT-F3.
Press firmly on the Velcro to affix it to the FOT-F3.
4. Similarly install the other half of the Velcro on the surface
on which you want to mount the FOT-F3.
5. Attach the FOT-F3 to the Velcro mount.