ClearSounds Photo50 V608 - Manual (Page 10)

10 – ENGLISH 11 – ENGLISH
of a message press the PLAY button and the message will pause
(max. 7 seconds). Press PLAY again to resume playback.
2 When playback is finished you will hear two short beeps, and the
machine will return to standby mode. all incoming messages are
saved (unless you have erased any during playback, see below),
new messages will then be recorded after the old ones.
the following functions are available during playback:
Button function
SKIP Skip to next message.
REPEAT repeats the current message, or hold down until you
hear a beep to step back through the messages
ON/OFF Stop playback.
DELETE Erase messages.
Playback through handset receiver
(+40dB volume)
To playback your messages, pick-up the handset and press PLAY, now
you can press the +40dB BOOST key to boost the message volume
to 40dB.
Delete Incoming Messages
If you want to delete a single incoming message press DELETE while
the message is playing.
To erase all messages after playback, press and hold DELETE until
unit beeps.
please note that new messages cannot be deleted until they have
been played.
call Screening
Incoming messages can be heard through the Speakerphone as they
are received. If there is no sound adjust the volume using the control
on the right side of the phone.
You can lift the handset to speak directly to the caller. If the recording
does not stop automatically, press ON/OFF on the answering machine,
or press * (2 seconds) on the telephone.
checking your messages from a remote
location.
This machine can be remotely controlled using the keys of an ordinary
tone dialing telephone. call up the answering machine and enter the
remote code while the outgoing message is playing. once the code
is accepted, several remote control commands are available.
Photo50-TriLingual.indd 10 7/6/08 11:11:12 AM