Dell PowerVault MD3220i - Manual (Page 17)

Getting Started With Your System
15
9 When the reboot is complete, the MDCU may launch automatically. If
the MDCU does not launch automatically, launch it manually.
• In a Windows-based operating system, click Start → Dell→ Modular
Disk Configuration Utility.
• In a Linux-based operating system, double-click the Modular Disk
Configuration Utility icon on the desktop.
NOTE:
If MDCU is not installed, see the Deployment Guide at
support.dell.com/manuals.
10 Start the MD Storage Manager and discover the array(s).
11 If applicable, activate any premium features purchased with your storage
array. If you purchased premium features, see the printed activation card
shipped with your storage array.
NOTE:
The MD Storage Manager installer automatically installs the required
drivers, firmware, and operating system patches/hotfixes to operate your storage
array. These drivers and firmware are also available at support.dell.com. In
addition, see the Support Matrix at support.dell.com/manuals for any additional
settings and/or software required for your specific storage array.
Locating Your Service Tag
Your system is identified by a unique Express Service Code and Service Tag
number. The Express Service Code and Service Tag are found on the front of
the system and at the back of the system next to the RAID controller
modules. This information is used by Dell to route support calls to the
appropriate personnel.