Craftsman G8693 - Manual (Page 22)

-22- G8693 Mini Shaper
Figure 19.
Your Mini Shaper has a rear chip discharge which
fits any standard dust collection with a 2
1 ⁄
2
'' hose.
A 2 1 ⁄
2
'' to 1 1 ⁄
4
'' hose adapter is supplied with the
Mini Shaper. Attaching a dust collection system
will keep your work area cleaner.
If Chip Discharge clogs with chips, turn switch
OFF and UNPLUG unit to avoid accidental start-
ing. Dislodge chips and debris with a pencil or
wood dowel, minimum 6 inches in length.
Do not use finger since stationary blades are
sharp.
When resuming operation, feed at a slower rate
to avoid re-clogging. Use of a Wet-Dry Vac will
virtually eliminate the chance of clogging.
Never leave hose connected to the machine dur-
ing operation if a vac is not turned on. The hose
and machine will clog with chips.
Dust Collection