Craftsman G8693 - Manual (Page 16)

-16- G8693 Mini Shaper
The Spindle has a maximum vertical adjustment
of
3 ⁄
4
''. The large knob on the rear of the Shaper/
Router is used to set the height. Loosen the knob
by turning it counterclockwise. The Spindle
assembly can now be raised or lowered by mov-
ing the knob right or left in the inclined slot. When
the desired height is obtained, turn the knob
clockwise to lock it in place. See
Figure 11.
Spindle cutters can be raised by using the collar
(REF 59) provided.
Spindle Height
Figure 11. Spindle height locking knobs.
The Table Insert (REF 16) should be used at all
times to provide support for the workpiece.
When the cutter or bit is completely above the
table surface, the Table Insert should be used with
the smaller (1
3 ⁄
8
'') hole facing up. See Figure 9.
When the cutter or router bit is below the surface
of the table, the Table Insert should be used with
the 2-
5 ⁄
8
'' opening facing up. See Figure 10.
Always make sure the cutter will not hit the Insert
before turning on the Mini Shaper.
Table Insert
Figure 9. Guard Removed For Clarity.
Figure 10. Guard Removed For Clarity.
Insert Removed
Insert Installed