Craftsman G8693 - Manual (Page 12)

-12- G8693 Mini Shaper
Fence
1. Find three Knobs (REF 14) and three rubber
faced Washers (REF 13) from the parts bag.
2. Mount the Fence Body (REF 12) on the Table
(REF 10) using two knobs and washers.
Screw the knobs through the slots of the fence
body and into the threaded holes near the rear
of the table. See
Figure 4.
3. Place the Fence Segment (REF 15) in the V
groove on the Fence Body and screw the third
knob and washer into the threaded hole in the
Fence Body.
4. If you plan to use a dust collection system with
your mini Shaper, attach the Dust Port to the
back of the Fence using the four M5-0.8 x
10mm screws supplied.
Ring Guard
1. Attach the Ring Guard (REF 19) to the Post
(REF 21) using one #10-24 x
1 ⁄
2
'' Pan Head
Screw (REF 18).
2. Slide the assembly into the unthreaded hole
near the rear of the table.
3. Use knob (REF 14) from the parts bag to set
the height of the Ring Guard. See
Figure 5.
Figure 4. Mounting Fence Body On Table.
Figure 5. Guard installed.