Dell PowerVault MD3200i - Manual (Page 19)

Getting Started With Your System
17
Management Ethernet
connector One 100/1000 Base-T port Ethernet for out-of-band
management of the enclosure
NOTE:
The default management port IP addresses for
the primary and secondary RAID controller modules
are 192.168.128.101 and 192.168.128.102, respectively.
By default, the management ports are set to Dynamic
Host Configuration Protocol (DHCP). If the controller is
unable to get an IP address configuration from a DHCP
server within a specified time out period
(approximately 3 minutes), it defaults back to static IP
addressing. For more information, see the Deployment
Guide.
Expansion
PowerVault MD1200 series Supports a maximum of 192 hard drives with any
combination of PowerVault MD1200 or PowerVault
MD1220 expansion enclosures. Support for 192 hard
drives is a Premium Feature and requires activation.
The maximum number of hard drives supported
without using the Premium Feature is 120.
Redundant path connectivity provides redundant
data paths to each hard drive.
Backplane Board
Connectors • 12 or 24 SAS hard-drive connectors
• Two power supply/cooling fan module connectors
• Two sets of RAID controller module connectors
• One control panel connector for front LEDs and
enclosure mode switch
Sensors Two temperature sensors
Back-Panel Connectors (Per RAID Controller Module) (continued)