Cobalt Networks 9084 - Manual (Page 24)

2
Setting Up 9084 Network Remote Control
2-4 9084 PRODUCT MANUAL 9084-OM (V4.0)
Figure 2-2 Rear I/O Module Installation
Setting Up 9084 Network Remote Control
Perform remote control setup in accordance with Cobalt ® reference guide
“COMPASS™ Remote Control User Guide” (PN 9000RCS-RM).
Note: • If network remote control is to be used for the frame and the frame has not
yet been set up for remote control, Cobalt ® reference guide COMPASS™
Remote Control User Guide (PN 9000RCS-RM) provides thorough infor-
mation and step-by-step instructions for setting up network remote control of
COMPASS™ cards using DashBoard™. (Cobalt
® OGCP-9000 and
OGCP-9000/CC Remote Control Panel product manuals have complete
instructions for setting up remote control using a Remote Control Panel.)
Download a copy of this guide by clicking on the Support>Downloads link
at www.cobaltdigital.com and then select DashBoard Remote Control Setup
Guide as a download, or contact Cobalt
® as listed in Contact Cobalt Digital
Inc. (p. 1-15).
• If installing a card in a frame already equipped for, and connected to
DashBoard™, no network setup is required for the card. The card will be dis-
covered by DashBoard™ and be ready for use.
DSCN3483A.JPG
Align and engage mounting tab on Rear
I/O Module with the module seating slot
on rear of frame chassis.
Hold top of Rear I/O Module flush against
frame chassis and start the captive screw.
Lightly tighten captive screw.
DSCN3487A.JPG
1
2