Cobalt Networks 9084 - Manual (Page 23)

9084-OM (V4.0) 9084 PRODUCT MANUAL 2-3
Installation and Setup
Installing a Rear I/O Module
Note: To remove a card, press down on the ejector tab to unseat the card from the
rear I/O module mating connector. Evenly draw the card from its slot.
10. If network remote control is to be used for the frame and the frame has
not yet been set up for remote control, perform setup in accordance with
Setting Up 9084 Network Remote Control (p. 2-4).
Note: If installing a card in a frame already equipped for, and connected to
DashBoard™, no network setup is required for the card. The card will be dis-
covered by DashBoard™ and be ready for use.
Figure 2-1 9084 Rear I/O Module Connections
Installing a Rear I/O Module
Note: This procedure is applicable only if a Rear I/O Module is not currently
installed in the slot where the 9084 is to be installed.
If installing the 9084 in a 8310-C-BNC or 8310-BNC frame (which is
pre-equipped with a 100-BNC rear I/O module installed across the entire
backplane) or a slot already equipped with a suitable I/O module, omit this
procedure and go to Installing the 9084 Into a Frame Slot (p. 2-1).
Install a Rear I/O Module as follows:
1. On the 8310 frame, determine the slot in which the 9084 is to be installed.
2. In the mounting area corresponding to the slot location, install
Rear I/O Module as shown in Figure 2-2.
Both the built-in Rear I/O Modules on the 8310-BNC/
8310-C-BNC frames and the optional RM-9084-A Rear I/O
Module use the connector arrangements shown to the left.
Connect cabling as shown. Unused connectors do not
require external termination.