Crimestopper Security Products CS-2008PC - Manual (Page 4)

WIRING
PIN 12: ORANGE WIRE: NEGATIVE ARMED OUTPUT – Starter Disable (500mA Ground, Optional)
This wire becomes a (-) Ground output when system is armed. This output can be used for optional
accessories such as window roll up modules, scanner LED’s, voice modules, etc.
PIN 13: BLUE: NEGATIVE UNLOCK OUTPUT / POSITIVE LOCK OUPUT.
PIN 14: GRAY WIRE: (-) AUX REMOTE OUTPUT #1 (Optional, Programmable)
Connect to the negative activation circuit of a power trunk, hatch, or auxiliary device. This output can be
configured for PULSED, TIMED, or LATCHED. See Programming Options Section for more information.
PIN 15: GREEN: NEGATIVE LOCK OUTPUT / POSITIVE UNLOCK OUPUT.
PIN 16: BLUE/WHITE WIRE: (-) PASSENGER DOOR UNLOCK OUTPUT (Optional, requires relay)
Connects to unlock circuit for passenger door(s) when using separate driver’s door unlock option. See
SEPARATE DRIVER’S DOOR UNLOCK WIRING for configuration options.
PIN 17: BROWN/WHITE WIRE: (-) HORN HONK / CHIRP OUTPUT (Optional, may require a relay)
Connect to the Negative Horn Trigger wire for a horn honk during an alarm trigger. Horn activation wire is
usually located near the steering column. If the Horn circuit requires +12Volts, then a relay is required.
RELAY WIRING: Connect the Brown/White wire to terminal 85 of a relay. Connect terminals 86 and 87 to +12
Volts constant power. Connect terminal 30 to the Positive horn activation circuit.
PIN 18: BLACK/YELLOW WIRE: (-) AUX REMOTE OUTPUT #3 (Optional, Programmable)
Connect to the negative activation circuit of an auxiliary device or accessory. This output can be configured for
PULSED, TIMED, or LATCHED. See Programming Options Section for more information.
PIN 19: RED/BLACK WIRE: LED OUTPUT
Connect to the 2-pin Red LED harness to the 2-pin socket in system’s the main wire loom
PIN 20: BLACK/WHITE WIRE: DOME LIGHT ILLUMINATION OUTPUT 10A On-Board Relay (+ or -)
Connect this wire to the vehicle’s dome light activation circuit (May also be connected at the same point as the
Door Pin Switch input). This output will turn on the vehicle’s dome light when the system is disarmed using the
remote control. The +/- polarity of this output of this wire can be changed moving a jumper inside the control
module housing. DEFAULT output is Negative.
PIN 21: WHITE WIRE: FLASHING PARKING LIGHT OUTPUT 10A On-Board Relay (+ or -)
Connect this wire to the vehicle’s parking light circuit. The +/- polarity of this output of this wire can be
changed moving a jumper inside the control module housing. DEFAULT output is Positive.
PIN 22: RED WIRE: +12V POWER INPUT (15 Amp Fuse)
Connect to a +12 Volt source with the supplied fuse and fuse-holder. We recommend the Battery positive
terminal.