Crimestopper Security Products CS-2008PC - Manual (Page 11)

OPTION PROGRAMMING TABLE
PROGRAMMING OPTIONS CHART * = Default (Column 1)
Option
#
Option Description BUTTON 1*
LOCK
BUTTON 2
UNLOCK
BUTTON 3
TRUNK
1. Passive Arming/
Hands-free mode
Passive OFF*
Hands-free OFF*
Passive Arming
Enable
Hands-free Mode
Enable
2. Active Re-Arm /
Hands-free Immobilizer Active Re-arm OFF*
Immobilizer OFF*
Active Re-arm
Enabled
Immobilizer Enable
3. Silent Arm/Disarm
(Chirp Defeat)
Chirps* No Chirps
4. Lock when IGN turns ON/
Custom Override mode Enabled* Disabled Customized
Override Code
5. Unlock when IGN turns OFF Enabled* Driver’s door only NO IGN Unlock
6. Double Unlock Pulse 1 Pulse* 2 Pulses
7. Door Lock Pulse: 1 or 3 sec. 1 Second* 3 Seconds
8. Passive Lock Disabled* Enable
9. Beach Mode (Remote-less
Disarm) Disabled* Enable
10. Open Zone Warning 5 Seconds* OFF
11. Carjack Protection /
Factory Horn Chirps Carjack Disabled*
Horn chirps disabled*
Enable horn chirps Enable Carjack
12. Hands-free will trigger Carjack/
Horn Output Pulsed or Solid Hand free CJ Disabled*
Horn output pulsed*
Horn output
constant
Enable Hands-free
Carjack trigger
13. Aux 2 output actives when
system is armed Disabled* Enable
14. Aux #1 output type Pulsed* Timed Latched
15. Aux #2 output type Pulsed* Timed Latched
16. Aux #3 output type Pulsed* Timed Latched
17. Disarm with Aux #1
(Trunk pop) Disabled* Enable
18. Allow remote start when in
valet mode Enabled* Disable
19. Learn Tach/
Gas or Diesel Engine
Learn Tach RPM Set Gas Engine Set Diesel Engine
20. Self Start Mode/
W/temp, W/Voltage Drop Self Start Disabled* Self Start on Temp
setting
Self Start on voltage
drop
21. Enable 2-Way Pager Module/
Learn Hands-free Transmitter Enable 2-Way Pager
expansion module
Program extra 2-
way pager
Learn Hands-free
Transmitter
OPTION DESCRIPTIONS
1. PASSIVE ARMING / HANDS-FREE MODE
This option controls the Passive (Automatic) Arming feature and the Hands free mode. There are 3 selections:
Button 1 (Lock) = Both Passive Arming and Hands-free mode are OFF. Button 2 (Unlock) = Enable Passive
Arming. Button 3 (Trunk) = Enable Hands-free mode.
• If passive arming is enabled, arming will occur 30 Seconds after the ignition is turned off and the last door
has been closed. The LED will begin flashing rapidly while counting down. If a door is reopened, the
system will wait (LED solid) for the door or zone to close before arming. The unit will chirp once and flash
the lights once. Doors will lock if passive locking is selected. When passive arming is OFF, the system will
only arm/disarm with the remote.
• Button 3 enables the CS-2008PC to work with an optional Hands-free transmitter and all the features
corresponding to the Hands-free remote. To use hands-free remote features, the system must also be
programmed to passive arm and passive lock. (See Hands-Free Transmitter section: Pages 15 & 16)