beautypg.com

Ignition-lock / custom override, Ignition-unlocking, Double unlock pulse – Crimestopper Security Products CS-2008PC User Manual

Page 12: Door lock pulse time, Option descriptions

background image

OPTION DESCRIPTIONS

2. ACTIVE RE-ARMING / HANDS-FREE IMMOBILIZER
This option controls the Active Re-arming feature and the Hands-free immobilizer. There are 3 selections:
Button 1 (Lock) = Both Active Re-arming and Hands-free immobilizer are OFF. Button 2 (Unlock) = Enable
Active Re-arming. Button 3 (Trunk) = Enable Hands-free immobilizer.
• Active Re-arming allows the system to re-arm itself 30 seconds after disarmed with the transmitter if a door

has not been opened. This is handy if the vehicle is accidentally disarmed (via the Transmitter in your
pocket) without your knowledge.

• Button 3 enables an “immobilizer feature only when using the optional Hands-free transmitter. This option

increases the security of the system. The starter disable will not disarm unless the Hands-free remote is
present and the CS-2008PC receives its signal. To use hands-free transponder features, the system must
be set up with the following conditions: Hands-free operation must be activated through Programming
option #1. A hands free transmitter must be programmed to work with the system through Programming
Option # 21. The system must be set to Passive arm and Passive lock, Options #1 & #8.

3. SILENT ARMING / DISARMING (CHIRP DEFEAT)
With this feature, the system can be programmed to Arm and Disarm without the siren chirp using the regular
Lock/Unlock Buttons. Flashing parking lights will be the only Arm/Disarm confirmation.

4. IGNITION-LOCK / CUSTOM OVERRIDE
This option controls whether the door locks when Ignition is turned on and the custom override feature. There
are 3 selections: Button 1 (Lock)= Lock with vehicle Ignition ON. Button 2 (Unlock)= Do Not Lock with ignition.
Button 3 (Trunk)= Custom override programming mode. (See custom override section)
The custom override feature allows the CS-2008PC user to set a “personalized” override code. If the system
has to be manually disarmed (overridden) without the remote, the user can customize the number of button
presses (2-15x) to do this other than the default operation which is a single press and hold of the button.

5. IGNITION-UNLOCKING
This option controls door unlocking when Ignition is turned OFF. There are 3 selections: Button 1 (Lock)=
Unlock all doors when Ignition is turned OFF. Button 2 (Unlock) = Unlock Drivers door only*. Button 3
(Trunk)= NO Ignition Unlock. (*Only applicable when using optional Driver’s priority unlock feature.)

6. DOUBLE UNLOCK PULSE
The option controls whether the unit will send 2 unlock pulses when the Unlock button is pressed. This feature
may be required for interfacing this alarm with an existing Factory Keyless Entry or Alarm system in a vehicle.
These systems are found on some Nissan, VW, Toyota, and Lexus vehicles.

7.DOOR LOCK PULSE TIME
Controls the amount of time (1 sec. or 3 sec.) for the lock/unlock pulse. The 3 sec. setting is only required for
1980’/90’s European Vehicles that require a long pulse to do Vacuum door lock systems.

8. PASSIVE LOCKS
This option controls whether the doors will lock when Passive Arming occurs. Note: May increase the risk of
locking keys in the vehicle. When selected ON, the alarm will lock the doors when passive arming.

9. “BEACH MODE” REMOTE-LESS DISARM (Note: this option requires Passive arming/Passive locks)
This option allows the system to be disarmed without the remote as long as the key is inserted and turned ON
within 10 seconds. This feature only operates after the system has passively armed. Upon opening the door,
the siren will chirp for 10 seconds, the key must be inserted and turned on, or the alarm will trigger.

10. DOOR OPEN WARNING
This option controls the door the delay time in which the alarm system begins to monitor the Door circuit. If
your system begins to give you warning chirps because of delay dome light or courtesy lighting, then disable
this option by selection Button #2 (unlock).

11. CARJACK PROTECTION / ARM-DISARM HORN CHIRPS (2 FEATURES)
This option controls whether the system’s Horn output will chirp for arm/disarm AND Carjack protection
features. There are 3 selections: Button 1 (Lock) = Horn Chirps and Full-time Carjack are disabled. Button 2
(Unlock) = Enable Horn Chirping for Arm / Disarm. Button 3 (Trunk) = Enable Carjack protection.