Contec SPI-8451-LVA - Manual (Page 49)

6. RAID Controller
42
SPI-8451-LLVA, SPI-8452-LLVA, SPI-8451-LVA
3. Install the hard drives into the hard drive bays of your system, including the power cables.
4. Attach one Ultra ATA cable to each hard drive. Then attach one cable to each of the IDE connector
on the SPI-8451-LLVA board. The colored edge of the cable(s) indicates pin 1, and the blue cable
connector must be attached to the SPI-8451-LLVA connector.
CAUTION
You must use an 80-wire, 40-pin cable when connecting an Ultra ATA66/100 hard drive to the
SPI-8451-LLVA connector