CyberPower Systems CPS900AVR User Manual

Page 7

CPS900AVR

Guaranteed Uninterruptible Power System

9. Load

Level: This indicator shows the % of capacity of the battery outlets that is currently being used. If the load level exceeds 90%, the indicator

will change to a red color.

10. Output

Voltage: This indicator shows the output voltage of the UPS.

POWERPANEL™ PLUS SETUP WINDOW

Sensitive to Variation on Line Voltage: This feature is for other CyberPower Products. Since the 1250AVR has Automatic Voltage Regulation,
this feature is not necessary.

2. Auto-Restart: This feature allows the UPS to restore power to the battery outlets once the power is restored after a power failure.
3. Software

Broadcast: With this option enabled, the software will play audible voice messages through your computer speakers. A sound card

and speakers are required.

Time Between Power Failure and Shutdown: This is the user controllable delay between when the power fails and the software starts the
shutdown process. If unchecked, the unit will run on battery until the low battery signal is received (2 minutes of backup time remaining) and then
start the shutdown process.

Time Between Power Failure and Initial Warning: This setting determines the delay between when the power fails and the first audible alarm.

Delay Between Warning Messages: User adjustable setting for the delay between the audible alarms that occur during a power failure.

7. UPS

Self-Test: Allows the user to test the UPS without having to unplug the unit from the wall. When Run is clicked, the will switch to battery

power and the unit will beep.

8. About: This button will display information about the software, as well as contact information.
9. Advance: This button opens the Advanced Setup Window.
10. Default: Click this button to return the software to original factory settings.
11. Cancel: This button exits the window without saving changes.
12. OK: This button exits the window and saves changes.
13. UPS is Installed On: This shows the COM port that the UPS is using. The port assigned to the UPS needs to be used exclusively for the

PowerPanel Plus™ software.

14. Buzzer:

This toggles the audible alarm on and off.

POWERPANEL PLUS™ ADVANCED SETUP

Low Battery Voltage: This sets the low battery cutoff level. The user can slightly extend the UPS run time by adjusting this setting.

High-Voltage Failure: Sets the upper level where the UPS will cycle to battery. This level can be adjusted from 140v to 150v.

3. Low-Voltage

Failure: Sets the lower level where the UPS will cycle to battery. This level can be adjusted from 85v to 95v.

4. Battery-mode

Output

Voltage: Sets the voltage that the unit will output when running on battery. This level can be adjusted from 100v to 125v.

5. Cold

Start:

When this is enabled, the UPS can start in the absence of AC power. To maximize battery life, it is recommended to keep this

disabled.

6. Default: Restores the settings to the factory defaults.
7. Cancel: Exits the window without saving changes.
8. OK: Exits the windows and saves changes.
9.

Remote On Function: This function is not available on this model.