Clarion GRAND CHEROKEE PSWJPGC - Manual (Page 3)

3
II. RUN WIRE HARNESS
A. Run harness to the rear driver’s side wheel well hump.
III. TEST THE ENCLOSURE
A. Remove security shade from the rear cargo area.
B. Place the enclosure into the vehicle (the enclosure rests on the
two rear wheel well humps, the subwoofer will aim toward the
back of the vehicle).
C. Plug the wire harness into the enclosure.
D. Plug in the “T” harness behind the radio (or hard wire the sup-
plied ‘pigtail’ harness to the factory wiring).
E. Test for proper operation.
F. Adjust subwoofer gain (gain pod is located on the amplifier next
to the wire harness connector, and is adjustable with a Phillips
screw driver).
IV. ATTACH THE ENCLOSURE
A. Reinstall the rear security shade.
B Position the enclosure so that it is centered between the wheel
wells.
C. Prepare the provided template by cutting out the indicated sec-
tions.
D. Mark the correct location for each of the hook bases onto each
wheel well.
E. Attach the hook base to the vehicle using the (2) supplied 1"
self-taping screws (the hook will have to be removed from its
base for this step).
F. Reattach the hook to the base.
G. Latch the hook onto the metal bracket on the enclosure.