Compaq MP3800 - Manual (Page 50)

7–2 Compaq iPAQ Microportable Projector MP3800 User’s Guide
Care and Maintenance
■ Do not drop the projector or place it on an unstable surface.
■ Do not expose the projector to rain or moisture.
■ Do not allow anything to rest on the power cord. Do not walk
on the cord.
■ Do not allow the projector to be exposed to high
temperatures.
■ Do not open the projector or attempt to service this product
for any reason other than to replace the lamp module. Adjust
only those controls that are covered by the operating
instructions. If the projector is not operating properly or has
been dropped or damaged, contact your Compaq authorized
dealer, reseller, or service provider.
Cleaning the Lens
To minimize the risk of damaging or scratching the lens surface,
follow this cleaning procedure. First, remove any dust particles
from the lens by blowing them off with clean, dry, deionized air.
However, this may not be a convenient method, and an alternate
method is described below.
To clean the lens, use only a clean cloth and follow these steps:
Ä
CAUTION: Do not spray any type of fluid or cleaner directly on the lens
surface. Do not use liquid cleaners.
1. Wipe the lens in a single direction with a clean, dry cloth.
Do not wipe back and forth across the lens surface.
2. If the cloth is dirty or smears the lens, wash the cloth. If the
cloth is still dirty after washing it or the fabric is damaged,
replace it. Do not use fabric softener when washing a
cleaning cloth or softener sheets when drying the cloth.
Ä
CAUTION: Do not store a cleaning cloth in contact with the lens for a
long time as doing so may contaminate the lens with dye from the cloth.
The cloth can be contaminated if left in the open air.
281124-001.book Page 2 Tuesday, April 30, 2002 10:00 AM