Dell PowerEdge 1850 - Manual (Page 16)

1-14
Rack Installation Guide
4 Push the system into the mounting rails until the system stops (see Figure 1-7).
5 Push in and turn the thumbscrews on each side of the front chassis panel to secure the system
to the rack.
6 Install the optional front bezel (if applicable). See the procedures for installing the bezel in
the documentation provided with your system.
NOTE:
Figure 1-7 applies to the RapidRails, VersaRails, and two-post rack kits.
Installing the Releasable Tie Wraps
The two releasable tie wraps are used to secure your system’s cables to the mounting rails.
1 Locate the releasable tie wrap attachment points located on the two back mounting-bracket
flanges (see Figure 1-8).
2 Push the tie wrap’s fastener through the attachment point.
3 Push the tie wrap’s plunger until it snaps to secure the tie wrap to the mounting rail.
4 Using the releasable tie wrap, secure your system’s cables to the mounting rail.
Figure 1-8. Installing the Releasable Tie Wraps
mounting rails (2)
releasable tie wraps (2)