Cisco 1604 User Manual
Page 9
![background image](/manuals/60717/9/background.png)
3-9
Cisco IOS Dial Services Quick Configuration Guide
Chapter 3
Configuring the Cisco 1604 Router
Verifying the Ethernet Interface Configuration
Step 3
Establish connectivity with an Ethernet-based device. In this example, IP address 10.1.4.2 is assigned
to the first external PC on this LAN to test for router-to-PC connectivity. The PC’s DOS prompt
application is opened and the ping 10.1.4.1 command is issued.
Microsoft(R) Windows 95
(C)Copyright Microsoft Corp 1981-1996.
C:\WINDOWS> ping 10.1.4.1
Pinging 10.1.4.1 with 32 bytes of data:
Reply from 10.1.4.1: bytes=32 time=3ms TTL=236
Reply from 10.1.4.1: bytes=32 time=2ms TTL=236
Reply from 10.1.4.1: bytes=32 time=3ms TTL=236
Reply from 10.1.4.1: bytes=32 time=2ms TTL=236
Step 4
Ping the PC from the Cisco 1604. If the PC has not yet used any IP services or drivers, the connection
might fail. The preferred method is to ping the router from a PC on the LAN first:
robo-austin# ping 10.1.4.2
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.1.4.2, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 4/5/8 ms
Step 5
If you know that the Ethernet interface is up but not performing correctly, enter the show interface
ethernet 0 command. This example shows errors in the counters because the Ethernet cable was not
plugged in:
robo-austin# show interface ethernet 0
Ethernet0 is up, line protocol is up
Hardware is QUICC Ethernet, address is 0060.834f.6626 (bia 0060.834f.6626)
Internet address is 10.1.4.1/24
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec, rely 234/255, load 1/255
Encapsulation ARPA, loopback not set, keepalive set (10 sec)
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:08, output 00:00:04, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
2 packets input, 644 bytes, 0 no buffer
Received 2 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 input packets with dribble condition detected
28 packets output, 2905 bytes, 0 underruns
25 output errors, 0 collisions, 2 interface resets
0 babbles, 0 late collision, 0 deferred
3 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out