Dell PowerVault 56F (16P Fibre Channel Switch) User Manual
Dell Computer hardware
P/N 4049T Rev. A00
August 1999
This document explains how to install a gigabit interface converter (GBIC) module in a
Dell PowerVault 50F or 51F Fibre Channel switch.
NOTES: You can insert GBIC modules into a switch while the switch is on.
GBIC modules use standard SC connectors or high-speed serial data connectors
(HSSDC).
To install a GBIC module in a PowerVault 50F or 51F, perform the following steps:
1.
If you are installing a non-IBM
®
GBIC module, perform only steps 2 and 3.
If you are installing an IBM GBIC module, ensure that the locking bar on the front
of the GBIC module is pushed to the right side of the module.
2.
Insert the GBIC module into the appropriate port.
3.
Press the GBIC module until its connector is firmly seated.
4049Tam0.fm Page 1 Thursday, October 7, 1999 9:35 AM
Document Outline
- Installing a GBIC Module in a Dell™ PowerVault™50F or 51F Fibre Channel Switch
- Installation d’un module GBIC dans un commutateur Fibre Channel Dell™ PowerVault™ 50F ou 51F
- Ein GBIC Modul in einen Dell™ PowerVault™50F oder 51F Faserkanal-Schalter einbauen
- Instalación de un módulo GBIC en un interruptor de canal de fibra Dell™ PowerVault™50F ó 51F