Chief Manufacturing KSA-1004 - Manual (Page 6)

Installation Instructions FSA/KSA-1004
6
Adjusting Lateral Movement
CAUTION: Over-tightening tension bolt will cause
excessive wear and may distort adjustment
components.
To adjust the lateral movement tension, perform the
following procedures:
1. Slightly tighten or loosen the tension adjustment bolt.
2. Check for desired tension. Repeat as necessary.
Adjusting Lift Arm Tension
CAUTION: Over-tightening tension bolt will cause
excessive wear and may distort adjustment
components.
To adjust the tension of the lift arm:
1. Raise or lower the lift arm until tension adjustment
bolt appears in the opening.
2. Using the 5/32” hex key (provided), adjust the
tension adjustment bolt, as follows:
NOTE: There is no fixed number of revolutions to turn
the tension adjustment bolt. Tighten or loosen
the bolt, as needed. When the bolt is adjusted
correctly, the display can be easily raised or
lowered at any time, and stay in place without
sagging.
a. To increase lift arm tension, turn the tension
adjustment bolt counterclockwise.
b. To decrease lift arm tension, turn the tension
adjustment bolt clockwise.
3. Raise or lower the lift arm to check for desired
tension. Repeat step 2 as needed.
Adjusting Lateral Movement
Lateral
Tension
Adjustment
Bolts
(Typical)
Adjusting Lift Arm Tension
Lift Arm Tension
Adjustment Bolt