Canon 4.1 - Manual (Page 33)

33
S T E P 2
Scanning
Once you have set the magnification and scan mode, you may proceed with the
scan. Once the scan is complete, close Plug-in Module CS-U. The scanned image
will appear in the application software, such as CanoScan Toolbox or Adobe
Photoshop LE.
To Initiate the Scan
Specify the Scan Area.
See Setting the Scan Area (p. 30) .
Click on the [Scan] button.
• The scan will start.
Click (close box) to guit the Plug-in Module CS-U.
• When you select [close Plug-in After Scan], the Plug-in Module CS-U quits
antomatically.
Hint
• The scan button cannot be clicked if the scan area is set too small (less
than 64x64 pixels) or not specified.
• The scan cannot be performed if the required memory is larger than the
free disk space.
➟