Baumer HS35 - Manual (Page 2)

Installation instruction protective cover HS35.doc 2/2 www.baumer.com/motion
2012-02-21/rnik
Mounting protective cover HS35
• The incremental encoder must be slide on to
driveshaft by hand. Do not force! If necessary check
and verify the driveshaft diameter.
• The torque support on mounting side (e.g. motor B-
shield) shown in graphic [1] fastening without
pressure. Tightening torque max. 1700 oz-in (max.
12 Nm).
• The incremental encoder shaft fastening with the
clamping ring on the motor shaft. Tightening torque
of the clamping ring screw max. 312 oz-in (2.2 Nm).
• Protective cover according to graphics [2] put on the
mounting side and attach with the supplied
accessories (3x cylinder screw (0.75 inch long) with
flat washer and lock washer).
Tightening torque max. 2690 oz-in (max. 19 Nm).
• Set the contact protection clip into the opening
of the protective cover (connector/cable gland)
(graphics [3]).
• Protection label glue centred on the opening
of the protective cover (graphics [4]).
[1]
[2]
[3]
[4]
opening for
contact protection
clip
contact protection
clip
screw customer-supplied