beautypg.com

Universal garage door opener (homelink®), Before you begin programming homelink, Universal garage door opener – Dodge 2015 Grand_Caravan - User Guide User Manual

Page 71: Homelink

background image

Flashing Lights With Lock

The turn signal lights flash when the doors are locked, which can be turned on or off. To
turn this feature on or off:
• Push and hold the UNLOCK button and the LOCK button at the same time for at least

four seconds, but no longer than 10 seconds.

• Release both buttons at the same time.

UNIVERSAL GARAGE DOOR OPENER (HomeLink®)

HomeLink

®

replaces up to three hand-held transmitters that operate devices such as

garage door openers, motorized gates, lighting or home security systems. The HomeLink

®

unit is powered by your vehicles 12 Volt battery.

The HomeLink

®

buttons that are located in the overhead console or sunvisor designate the

three different HomeLink

®

channels.

The HomeLink

®

indicator is located above the center button.

Before You Begin Programming
HomeLink®

Ensure that your vehicle is parked outside
of the garage before you begin program-
ming.

For efficient programming and accurate
transmission of the radio-frequency signal,
it is recommended that a new battery be
placed in the hand-held transmitter of the
device that is being programmed to the
HomeLink

®

system.

To erase the channels, place the ignition
switch into the ON/RUN position, then
push and hold the two outside HomeLink

®

buttons (I and III) for up to 20 seconds or until the red indicator flashes.

NOTE:
Erasing all channels should only be performed when programming HomeLink

®

for the first

time. Do not erase channels when programming additional buttons.

If you have any problems, or require assistance, please call toll-free 1-800-355-3515 or,
on the Internet at HomeLink.com for information or assistance.

HomeLink® Buttons

E L E C T R O N I C S

69