beautypg.com

Dodge 2015 Charger - Owner Manual User Manual

Page 240

background image

2. Place the hand-held transmitter 1 to 3 inches (3 to 8 cm)

away from the HomeLink® button you wish to program

while keeping the HomeLink® indicator light in view.

3. Continue to push and hold the HomeLink® button,

while you push and release (“cycle”) your hand-held

transmitter every two seconds until HomeLink® has

successfully accepted the frequency signal. The indi-

cator light will flash slowly and then rapidly when

fully trained.

4. Watch for the HomeLink® indicator to change flash

rates. When it changes, it is programmed. It may take

up to 30 seconds or longer in rare cases. The garage

door may open and close while you are programming.

5. Push and hold the programmed HomeLink® button

and observe the indicator light.

• If the indicator light stays on constantly, program-

ming is complete and the garage door/device should

activate when the HomeLink® button is pushed.

• To program the two remaining HomeLink® buttons,

repeat each step for each remaining button. DO NOT

erase the channels.

If you unplugged the garage door opener/device for

programming, plug it back in at this time.
Reprogramming A Single HomeLink® Button
(Canadian/Gate Operator)
To reprogram a channel that has been previously trained,

follow these steps:
1. Cycle the ignition to the ON/RUN position.
2. Push and hold the desired HomeLink® button until

the indicator light begins to flash after 20 seconds. Do

not release the button.

3. Without releasing the button proceed with

“Canadian/Gate Operator Programming” step 2 and

follow all remaining steps.

238 UNDERSTANDING THE FEATURES OF YOUR VEHICLE