beautypg.com

To vary the speed setting – Dodge 2015 Charger - Owner Manual User Manual

Page 188

background image

NOTE:

• If your vehicle stays at standstill for longer than two

seconds, then the system will cancel and the brake

force will be ramped-out. The driver will have to apply

the brakes to keep the vehicle at a standstill.

• ACC cannot be resumed if there is a stationary vehicle

in-front of your vehicle in close proximity.

WARNING!

The Resume function should only be used if traffic
and road conditions permit. Resuming a set speed
that is too high or too low for prevailing traffic and
road conditions could cause the vehicle to accelerate
or decelerate too sharply for safe operation. Failure to
follow these warnings can result in a collision and
death or serious personal injury.

To Vary The Speed Setting

To Increase Speed
While ACC is set, you can increase the set speed by

pushing the SET + button.
The drivers preferred units can be selected through the

instrument panel settings if equipped. Refer to “Under-

standing Your Instrument Panel” for more information.

The speed increment shown is dependant on the chosen

speed unit of U.S. (mph) or Metric (km/h):
U.S. Speed (mph)

• Pushing the SET + button once will result in a 1 mph

increase in set speed. Each subsequent tap of the

button results in an increase of 1 mph.

• If the button is continually pushed, the set speed will

continue to increase in 5 mph increments until the

button is released. The increase in set speed is reflected

in the DID.

186 UNDERSTANDING THE FEATURES OF YOUR VEHICLE