beautypg.com

Turn signals, Lane change assist, High/low beam switch – Dodge 2015 Charger - Owner Manual User Manual

Page 160: Flash-to-pass

background image

Turn Signals

Move the multifunction lever up or down and the arrows

on each side of the instrument cluster flash to show

proper operation of the front and rear turn signal lights.
NOTE:

• If either light remains on and does not flash, or there is

a very fast flash rate, check for a defective outside light

bulb. If an indicator fails to light when the lever is

moved, it would suggest that the indicator bulb is

defective.

• A “Turn Signal On” message will appear in the Drivers

Information Display (DID) and a continuous chime

will sound if the vehicle is driven more than 1 mi

(1.6 km) with either turn signal on.

Lane Change Assist

Tap the lever up or down once, without moving beyond

the detent, and the turn signal (right or left) will flash

three times then automatically turn off.

High/Low Beam Switch

Push the multifunction lever away from you to switch

the headlights to high beam. Pull the multifunction lever

toward you to switch the headlights back to low beam.

Flash-To-Pass

You can signal another vehicle with your headlights by

lightly pulling the multifunction lever toward you. This

will turn on the high beam headlights until the lever is

released.
NOTE:

If the multifunction lever is held in the flash-to

pass position for more than 20 seconds, the high beams

will shut off.

158 UNDERSTANDING THE FEATURES OF YOUR VEHICLE