beautypg.com

To exit remote start mode and drive the vehicle – Dodge 2015 Challenger-SRT - Owner Manual User Manual

Page 31

background image

programmed). Then, the engine will start and the vehicle

will remain in the Remote Start mode for a 15-minute

cycle.
NOTE:

• If an engine fault is present, the vehicle will start and

then shut down 10 seconds later.

• The park lamps will turn on and remain on during

Remote Start mode.

• For security, power window and power sunroof op-

eration (if equipped) are disabled when the vehicle is

in the Remote Start mode.

• The engine can be started two consecutive times with

the RKE transmitter. However, the ignition must be

activated by pushing the START/STOP button twice

(or the ignition must be placed in the ON/RUN

position) before you can repeat the start sequence for a

third cycle.

To Exit Remote Start Mode Without Driving The
Vehicle
Push and release the REMOTE START button one time or

allow the engine to run for the entire 15-minute cycle.
NOTE:

To avoid unintentional shut downs, the system

will disable the one time push of the REMOTE START

button for two seconds after receiving a valid Remote

Start request.
To Exit Remote Start Mode And Drive The Vehicle
Before the end of 15 minute cycle, push and release the

UNLOCK button on the RKE transmitter to unlock the

doors, or unlock the vehicle using Passive Entry via the

door handles, and disarm the Vehicle Security Alarm (if

equipped). Then, prior to the end of the 15 minute cycle,

push and release the START/STOP button.

2

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 29