beautypg.com

Adding washer fluid, Exhaust system – Dodge 2014 Challenger - Owner Manual User Manual

Page 457

background image

Adding Washer Fluid

The windshield washer fluid reservoir is located in the

front of the engine compartment. Be sure to check the

fluid level at regular intervals. Fill the reservoir with

windshield washer solvent (not radiator antifreeze) and

operate the system for a few seconds to flush out the

residual water.
When refilling the washer fluid reservoir, apply some

washer fluid to a cloth or towel and wipe the wiper

blades clean. This will help blade performance.
To prevent freeze-up of your windshield washer system in

cold weather, select a solution or mixture that meets or

exceeds the temperature range of your climate. This rating

information can be found on most washer fluid containers.
The fluid reservoir will hold nearly 1 gal (4 L) of washer

fluid when the message “Low Washer Fluid” appears in

the Electronic Vehicle Information Center (EVIC) (if

equipped).

WARNING!

Commercially available windshield washer solvents
are flammable. They could ignite and burn you. Care
must be exercised when filling or working around
the washer solution.

Exhaust System

The best protection against carbon monoxide entry into

the vehicle body is a properly maintained engine exhaust

system.
If you notice a change in the sound of the exhaust system;

or if the exhaust fumes can be detected inside the vehicle;

or when the underside or rear of the vehicle is damaged;

have an authorized technician inspect the complete ex-

haust system and adjacent body areas for broken, dam-

aged, deteriorated, or mispositioned parts. Open seams

or loose connections could permit exhaust fumes to seep

into the passenger compartment. In addition, have the

7

MAINTAINING YOUR VEHICLE 455