beautypg.com

Lane change assist, High/low beam switch, Flash-to-pass – Dodge 2014 Challenger - Owner Manual User Manual

Page 169: Map/reading lights

background image

Lane Change Assist

Tap the lever up or down once, without moving beyond

the detent, and the turn signal (right or left) will flash

three times then automatically turn off.

High/Low Beam Switch

Push the multifunction lever away from you to switch

the headlights to high beam. Pull the multifunction lever

toward you to switch the headlights back to low beam.

Flash-To-Pass

You can signal another vehicle with your headlights by

lightly pulling the multifunction lever toward you. This

will turn on the high beam headlights until the lever is

released.
NOTE:

If the multifunction lever is held in the flash-to

pass position for more than 15 seconds, the high beams

will shut off.

Map/Reading Lights

These lights are mounted between the sun visors on the

overhead console. Each light is turned on by pressing the

lens. Press the lens a second time to turn off the light.

These lights also turn on when a door is opened, or when

the UNLOCK button on the Remote Keyless Entry (RKE)

transmitter is pressed, or when the dimmer control is

turned fully upward, past the second detent.

3

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 167