beautypg.com

Gate operator/canadian programming, Using homelinkĥ, Using homelink – Dodge 2011 Charger - Owner Manual User Manual

Page 253

background image

Gate Operator/Canadian Programming

Canadian radio-frequency laws require transmitter sig-
nals to “time-out” (or quit) after several seconds of
transmission – which may not be long enough for
HomeLink

௡ to pick up the signal during programming.

Similar to this Canadian law, some U.S. gate operators are
designed to “time-out” in the same manner.

It may be helpful to unplug the device during the cycling
process to prevent possible overheating of the garage
door or gate motor.

If you are having difficulties programming a garage door
opener or a gate operator, replace “Programming
HomeLink” Step 3 with the following:

3. Continue to press and hold the HomeLink

button,

while you press and release (“cycle”), your handheld
transmitter every two seconds until HomeLink

has

successfully accepted the frequency signal. The EVIC
display will change from “CHANNEL # TRAINING” to
“CHANNEL # TRAINED.”

If you unplugged the device for training, plug it back in
at this time.

Then proceed with Step 4 under “Programming
HomeLink

௡” earlier in this section.

Using HomeLink

To operate, press and release the programmed
HomeLink

௡ button. Activation will now occur for the

trained device (i.e., garage door opener, gate operator,
security system, entry door lock, home/office lighting,
etc.,). The handheld transmitter of the device may also be
used at any time.

3

UNDERSTANDING THE FEATURES OF YOUR VEHICLE

251

This manual is related to the following products: