beautypg.com

Dodge 2011 Charger - Owner Manual User Manual

Page 251

background image

2. Place the handheld transmitter 1 to 3 in (3 to 8 cm)
from the HomeLink

௡ buttons while keeping the EVIC

display in view.

For optimal training, point the battery end of the hand-
held transmitter away from the HomeLink

௡.

3. Simultaneously, press and hold both the chosen
HomeLink

௡ button and the handheld transmitter button

until the EVIC display changes from “CHANNEL #
TRAINING” to “CHANNEL # TRAINED.”

Then release both the HomeLink

௡ and handheld trans-

mitter buttons.

If the EVIC display states “DID NOT TRAIN” repeat
Step 3. If the signal is too weak, replace the battery in the
handheld transmitter.

It may take up to 30 seconds or longer in rare cases. The
garage door may open and close while you train.

NOTE:

Some gate operators and garage door openers

may require you to replace Step 3 with procedures noted
in the “Gate Operator/Canadian Programming” section.

4. Press and hold the just-trained HomeLink

௡ button. If

the channel has been trained, the EVIC display will now
state “CHANNEL # TRANSMIT.”

If the EVIC display still states “CHANNEL # TRAIN-
ING” repeat Step 3.

NOTE:

After training a HomeLink

௡ channel, if the

garage door does not operate with HomeLink

௡ and the

garage door opener was manufactured after 1995, the
garage door opener may have rolling code. If so, proceed
to Step 5.

5. Programming A Rolling Code System
At the garage door opener motor (in the garage), locate
the “Learn” or “Training” button.

3

UNDERSTANDING THE FEATURES OF YOUR VEHICLE

249

This manual is related to the following products: