beautypg.com

Transmitter battery replacement, General information – Dodge 2011 Challenger - Owner Manual User Manual

Page 28

background image

Transmitter Battery Replacement
The recommended replacement battery is CR2032.
NOTE:

Perchlorate Material – special handling may

apply. See www.dtsc.ca.gov/hazardouswaste/perchlorate
1. If the RKE transmitter is equipped with a screw,

remove the screw. With the RKE ransmitter buttons

facing down, use a flat blade to pry the two halves of the

RKE transmitter apart. Make sure not to damage the

elastomer seal during removal.
2. Remove and replace the battery. When replacing the

battery, match the + sign on the battery to the + sign on

the inside of the battery clip, located on the back cover.

Avoid touching the new battery with your fingers. Skin

oils may cause battery deterioration. If you touch a

battery, clean it with rubbing alcohol.

3. To reassemble the RKE transmitter case, snap the two

halves of the case together. Make sure there is an even

“gap” between the two halves. If equipped, install and

tighten the screw until snug. Test RKE transmitter

operation.

General Information
This device complies with Part 15 of the FCC rules and

RSS 210 of Industry Canada. Operation is subject to the

following conditions:

• This device may not cause harmful interference.
• This device must accept any interference received,

including interference that may cause undesired

operation.

NOTE:

Changes or modifications not expressly ap-

proved by the party responsible for compliance could

void the user’s authority to operate the equipment.

26 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE