beautypg.com

Gate operator/canadian programming, Using homelinkĥ, Reprogramming a single homelinkĥ button – Dodge 2011 Challenger - Owner Manual User Manual

Page 159: Using homelink, Reprogramming a single, Homelink௡ button

background image

Gate Operator/Canadian Programming
Canadian radio-frequency laws require transmitter sig-

nals to “time-out” (or quit) after several seconds of

transmission – which may not be long enough for

HomeLink௡ to pick up the signal during programming.

Similar to this Canadian law, some U.S. gate operators are

designed to “time-out” in the same manner.
It may be helpful to unplug the device during the cycling

process to prevent possible overheating of the garage

door or gate motor.
If you are having difficulties programming a garage door

opener or a gate operator, replace “Programming

HomeLink” Step 3 with the following:
3. Continue to press and hold the HomeLinkbutton,
while you press and release (“cycle”), your handheld
transmitter every two seconds until HomeLink
has
successfully accepted the frequency signal. The EVIC
display will change from “CHANNEL # TRAINING” to
“CHANNEL # TRAINED.”

If you unplugged the device for training, plug it back in

at this time.
Then proceed with Step 4 under “Programming

HomeLink௡” earlier in this section.

Using HomeLink
To operate, press and release the programmed

HomeLink௡ button. Activation will now occur for the

trained device (i.e., garage door opener, gate operator,

security system, entry door lock, home/office lighting,

etc.,). The handheld transmitter of the device may also be

used at any time.

Reprogramming A Single HomeLinkButton
To reprogram a channel that has been previously trained,

follow these steps:
1. Place the ignition in the RUN position.

3

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 157