Dodge 2010 Viper - User Guide - Manual (Page 34)

Track Extension
• A splitter track extension is included in the
trunk of every Viper ACR. The track extension
is mounted in the same location as the
center rub strip. The on-track aerodynamic
balance was optimized with the track
extension in place.
• To install the track extension, remove the
eight (8) screws of the center rub strip and
install the extension in the same mounting
locations.
• Tighten fasteners to 70 in-lbs (7.9 N·m).
CAUTION!
The track extension should only be used during closed circuit track events. The track
extension can cause premature damage to your vehicle if used on public roads.
Rear Wing
• The ACR rear wing generates most of the
car’s aerodynamic downforce.
• The wing is a powerful element that will
affect the handling of the car at speeds
greater than 50 mph. Extreme caution
should be given to any modifications to the
factory settings.
WARNING!
Do not operate the vehicle with the rear wing removed. The aerodynamic balance of
this setup is unstable and can cause the loss of control.
• Regularly inspect the wing panel and attachment points for damage or looseness.
• The Viper ACR on-track aerodynamics have been tuned and balanced for the vehicle
with the track extension installed.
PERFORMANCE/ACR
32