Dodge 2010 Viper - User Guide - Manual (Page 15)

Installing The Child Restraint Using The Vehicle Seat Belts
• To install a child restraint, first, pull enough of the seat belt webbing from the retractor
to route it through the belt path of the child restraint and slide the latch plate into the
buckle until you hear a “click.”
• Grasp the shoulder portion of the belt and pull all of the webbing out of the retractor.
• Allow some of the webbing to retract back into the retractor. As the belt retracts, you
will hear a clicking sound indicating that the belt is now in Automatic Locking Mode.
• Tighten the lap portion of the belt and allow the excess webbing to retract back to the
retractor. If it still does not make the child restraint secure, then secure the child
restraint with the Child Restraint Tether Anchor.
FRONT SEATS
WARNING!
Adjusting a seat while the vehicle is moving is dangerous. The sudden movement of
the seat could cause you to lose control. The seat belt might not be properly adjusted,
and you could be severely injured or killed. Only adjust a seat while the vehicle is
parked.
Manual Seat Adjustment
Forward/Rearward
• Lift up on the adjusting bar located at the
front of the seat near the floor and release
at the desired position.
13
GETTING STARTED