Chrysler Uconnect for Jeep - Manual (Page 21)

Three-Way Calling
To initiate three-way calling, press the
button
while a call is in progress, and make a second phone call,
as described under
ЉMaking a Second Call While Current
Call is in Progress.
Љ After the second call has established,
press and hold the button until you hear a double
beep, indicating that the two calls have been joined into
one conference call.
Call Termination
To end a call in progress, momentarily press the
button. Only the active call(s) will be terminated and if
there is a call on hold, it will become the new active call.
If the active call is terminated by the far end, a call on
hold may not become active automatically. This is cell
phone-dependent. To bring the call back from hold, press
and hold the
button until you hear a single beep.
Redial
• Press the
button to begin.
• After the ЉReadyЉ prompt and the following beep, say
ЉRedial.Љ
• The Uconnect™ Phone will call the last number that
was dialed from your cellular phone.
NOTE: This may not be the last number dialed from the
Uconnect™ Phone.
Call Continuation
Call continuation is the progression of a phone call on the
Uconnect™ Phone after the vehicle ignition key has been
switched to OFF. Call continuation functionality avail-
able on the vehicle can be any one of three types:
20 Uconnect™ Phone