Dodge 2010 Viper - Owner Manual User Manual

Page 201

3. Uncoil the Sealant Hose (6) and then remove the
yellow cap from the fitting at the end of the hose.

4. Place the TIREFIT kit flat on the ground next to the
deflated tire.

5. Remove the cap from the valve stem and then screw
the fitting at the end of the Sealant Hose (6) onto the
valve stem.

6. Uncoil the Power Plug (8) and then insert the plug into
the vehicle’s 12 Volt power outlet.

NOTE:

Do not remove foreign objects (e.g., screws or

nails) from the tire.

• Always start the engine before turning ON the TIRE-

FIT kit.

NOTE:

Manual transmission vehicles must have the

parking brake engaged and the shifter in NEUTRAL.

• After pressing the Power Button (4), the sealant (white

fluid) will flow from the Sealant Bottle (1) through the
Sealant Hose (6) and into the tire.

NOTE:

Sealant may leak out through the puncture in

the tire.

If the sealant (white fluid) does not flow

within 0 –

10 seconds through the Sealant Hose (6):

1. Press the Power Button (4) to turn OFF the TIREFIT
kit. Disconnect the Sealant Hose (6) from the valve stem.
Make sure the valve stem is free of debris. Reconnect the
Sealant Hose (6) to the valve stem. Check that the Mode
Select Knob (5) is in the sealant mode position and not air
mode. Press the Power Button (4) to turn ON the TIREFIT
kit.

WHAT TO DO IN EMERGENCIES

197