Shifting, Suggested up-shift speeds, Suggested maximum speed in each gear – NISSAN 2015 Xterra - Owner's Manual User Manual
Page 267

Shifting
To change gears, or when upshifting or down-
shifting, depress the clutch pedal fully, shift into
the appropriate gear, then release the clutch
slowly and smoothly.
To ensure smooth gear changes, fully depress
the clutch pedal before operating the shift lever. If
the clutch pedal is not fully depressed before the
transmission is shifted, a gear noise may be
heard. Transmission damage could occur.
Start the vehicle in 1st gear and shift to 2nd, 3rd,
4th, 5th and 6th gear in sequence according to
vehicle speed.
To back up depress the shift lever and then move
it to the R (Reverse) position after stopping the
vehicle completely.
If it is difficult to move the shift lever into R
(Reverse) or 1 (First), shift into N (Neutral), then
release the clutch pedal. Fully depress the clutch
pedal again and shift into R (Reverse) or 1 (First).
If your vehicle is equipped with 4-wheel drive,
refer to “Transfer case shifting procedures” in this
section.
Suggested up-shift speeds
The following are suggested vehicle speeds for
shifting into a higher gear. These suggestions
relate to fuel economy and vehicle performance.
Actual upshift speeds will vary according to road
conditions, the weather and individual driving
habits.
● 4-wheel drive models (4H position):
GEAR CHANGE
MPH (km/h)
1st to 2nd
11 (18)
2nd to 3rd
17 (27)
3rd to 4th
25 (40)
4th to 5th
32 (51)
5th to 6th
45 (72)
● 4-wheel drive models (4L position):
GEAR CHANGE
MPH (km/h)
1st to 2nd
—
2nd to 3rd
—
3rd to 4th
—
4th to 5th
—
5th to 6th
—
Suggested maximum speed in each
gear
Downshift to a lower gear if the engine is not
running smoothly, or if you need to accelerate.
Do not exceed the maximum suggested speed
(shown below) in any gear. For level road driving,
use the highest gear suggested for that speed.
Always observe posted speed limits, and drive
according to the road conditions, which will en-
sure safe operation. Do not over-rev the engine
when shifting to a lower gear as it may cause
engine damage or loss of vehicle control.
LSD0148
5-18
Starting and driving