Country Home Products DR ALL-TERRAIN FIELD and BRUSH MOWER - Manual (Page 13)

CALL TOLL FREE 1-800-DR-OWNER 9
CHAPTER 3
SETTING UP YOUR DR GENERATOR ATTACHMENT
This chapter covers the unpacking, attaching the Skids and the procedures necessary for connecting the DR
GENERATOR ATTACHMENT to your DR
ALL-TERRAIN Field and Brush Mower. If you have any questions
at all, please feel free to contact our Customer Service Representatives at our toll free number:
1-800-DR-OWNER (376-9637).
Unpacking & Attaching the Skids
NOTE: We recommend two people for unpacking, as the unit weighs 90 pounds.
Parts Supplied:
•
Generator Attachment
•
Interface Relay Harness
•
Drive Belt (same as Brush Deck)
•
(2) Skids
•
Crosspiece
•
(10) 5/16" Bolts, Washers & Lock Nuts
•
#10 Screw x 5/8" & #10 Lock Nut
•
Cable Ties
Tools Needed:
•
(2) 1/2" Open End Wrench
•
Phillips Screwdriver or optional wrench
1. Open the shipping container and remove the top packing piece and place it near the shipping
container ( Figure 1 ).
2. Remove the two (2) Skids, Crosspiece and the Parts Bag containing the Interface Relay Harness,
Cable Ties and Hardware from the shipping container ( Figure 1 ).
3. Carefully roll your new DR GENERATOR ATTACHMENT in the shipping container so that it rests
upside down on the packing material from Step 1 ( Figure 1 ).
NOTE: One person should steady the Generator while the other attaches the Skids.
4. Note the Hole locations in the Frame Sides as shown in ( Figure 2 ). There are two (2) Holes at the
front of the Frame and one (1) at the rear on either side. Orient the Skids to match the Hole
patterns.
5. Route the Generator Wire Harness through the Frame at the rear of the Generator as shown in
Figure 2 .
6. Place the Skids in the U-section Channel of the Frame and bolt them in place with six (6) Bolts,
Washers and Lock Nuts ( Figure 2 ).
NOTE: The Bolt heads and Washers are on the outside and Lock Nuts are on the inside (Figure 2).
Do not tighten completely at this time.
7. Bolt the Crosspiece to the front of the Skids using four (4) Bolts, Washers & Lock Nuts ( Figure 3 ).
Now tighten all of the hardware.
8. Tip the unit up right onto the Skids. The assembly is now complete.
NOTE: Do not discard your packaging material until you are fully satisfied with your new DR
GENERATOR ATTACHMENT.