NISSAN 2012 Titan - Owner's Manual - Manual (Page 335)

KEYFOB (if so equipped)
Replace the battery in the keyfob as follows:
᭺
1 Open the lid using a coin
᭺
A .
᭺
2 Remove the battery
᭺
B .
᭺
3 Install a new battery
᭺
C with the “+” facing
down.
● Hold the battery by the edges. Holding the
battery across the contact points will seri-
ously deplete the storage capacity.
● Do not touch the internal circuit and electric
terminals as it could cause a malfunction.
● When changing the battery, do not let dust
or oil get on the keyfob.
● There is danger of explosion if a lithium bat-
tery is incorrectly replaced. Replace only
with the same or equivalent type.
Recommended battery: CR2025 or equivalent.
᭺
4 Close the lid securely.
5. Press the button, then the
button two or three times to check the key-
fob operation.
If the battery is removed for any reason
other than replacement, perform step 5.
● An improperly disposed battery can
hurt the environment. Always confirm
local regulations for battery disposal.
● The keyfob is water-resistant; how-
ever, if it does get wet, immediately
wipe completely dry.
● The operational range of the keyfob
extends to approximately 33 ft (10 m)
from the vehicle. This range may vary
with conditions.
LDI2026
8-26 Maintenance and do-it-yourself