Route calculation and visual guidance -6, Route calculation and visual guidance – NISSAN 2015 GT R - Multi Function Display Owner's Manual User Manual
Page 285
12-6
Troubleshooting guide
ROUTE CALCULATION AND VISUAL
GUIDANCE
Symptom
Possible cause
Possible solution
Waypoints are not included in the auto
reroute calculation.
Waypoints that have been already passed are not included in the auto
reroute calculation.
To go to that waypoint again, edit the route.
Route information is not displayed.
Route calculation has not yet been performed.
Set the destination and perform route calculation.
The vehicle is not on the suggested route.
Drive on the suggested route.
Route guidance is set to off.
Turn on route guidance.
Route information is not provided for certain types of roads (roads
displayed in gray).
This is not a malfunction.
The auto reroute calculation (or detour
calculation) suggests the same route as
the one previously suggested.
Route calculations took priority conditions into consideration, but the
same route was calculated.
This is not a malfunction.
A waypoint cannot be added.
Five waypoints are already set on the route, including ones that the
vehicle has already passed.
A maximum of 5 waypoints can be set on the route. To
go to 6 or more waypoints, perform route calculations
multiple times as necessary.
[Calculate] must be selected for route calculation after Waypoints are
selected from the “Edit/Add to Route” screen.
Highlight [Calculate] and push
ing waypoints.
The suggested route is not displayed.
Roads near the destination cannot be calculated.
Reset the destination to a main or ordinary road, and
recalculate the route.
The starting point and destination are too close.
Set a more distant destination.
The starting point and destination are too far away.
Divide the trip by selecting one or two intermediate
destinations, and perform route calculations multiple
times.
There are time restricted roads (by the day of the week, by time) near
the current vehicle location or destination.
Set [Use Time Restricted Roads] to off.
“Setting conditions for route calculation”
(page 2-65)
A part of the route is not displayed.
The suggested route includes narrow streets (roads displayed in gray). This is not a malfunction.