NISSAN 2012 GT R - Owner's Manual - Manual (Page 109)

Black plate (108,1)
R35-D EDITED: 2011/ 2/ 4
2-14 Instruments and controls
after the system check is finished.
Release the button and push it again
to operate the shift lever.
. During winter or at other times when
the temperature is extremely low,
changes in the hydraulic response
characteristic s may increase the
amount of time that is required for the
system check. During the system check,
a thudding operating noise may occur
or the engine speed may decrease,
however this does not indicate that
there is a malfunction.
1. ENTER switch
2. NEXT switch
3. Vehicle information display
The drive computer displays the following
information:
. Current fuel consumption
. Vehicle speed
. Cruise control
. Average fuel consumption and speed
. Elapsed time and trip computer
. Distance to empty
. Outside air temperature
. Setting
. Warning
The vehicle information display
*
3 can be
changed when the ignition switch is in the ON
position. Press the ENTER switch
*
1 to
change the display.
NOTE:
. The cruise control display is shown if
cruise control is set. ( “Cruise con-
trol” page 5-34)
. The warning display is not shown if
there are no conditions to warn the
driver.
. Depending on the driving conditions
and other factors, the displayed values
may differ from the actual values.
. The position of the speedometer nee-
dle and the speed shown in the vehicle
information display may slightly differ.
DRIVE COMPUTER