NISSAN 2013 Cube - Owner's Manual - Manual (Page 273)

Black plate (271,1)
[ Edit: 2012/ 7/ 19 Model: Z12-D ]
After the operation
1. Install the engine undercover into position as
the following steps.
a. Pull the center of the small plastic clips
out.
b. Hold the engine undercover into position.
c. Insert the clips through the undercover
into the holes in the frame, then push the
center of the clips in to lock the clips in
place.
d. Install the bolts that hold the undercover
in place. Be careful not to strip the bolts
or over-tighten them.
2. Lower the vehicle carefully to the ground.
3. Dispose of waste oil and filter properly.
WARNING
. Prolonged and repeated contact
with used engine oil may cause skin
cancer.
. Try to avoid direct skin contact with
used oil. If skin contact is made,
wash thoroughly with soap or hand
cleaner as soon as possible.
. Keep used engine oil out of reach of
children.
When checking or replacement is required, we
recommend a NISSAN dealer for servicing.
CAUTION
. Use only Genuine NISSAN CVT Fluid
NS-2. Do not mix with other fluids.
. Using transmission fluid other than
Genuine NISSAN CVT Fluid NS-2
will damage the CVT, which is not
covered by the NISSAN new vehicle
limited warranty.
Maintenance and do-it-yourself 8-11
CONTINUOUSLY VARIABLE
TRANSMISSION (CVT) FLUID
Condition: