NISSAN 2013 Cube - Owner's Manual - Manual (Page 196)

Black plate (194,1)
[ Edit: 2012/ 7/ 19 Model: Z12-D ]
4-54 Center display, heater, air conditioner, audio and phone systems
SAA2351
CONTROL BUTTONS
The control buttons for the Bluetooth ® Hands-
Free Phone System are located on the steering
wheel.
PHONE SEND
Push the button to initiate a VR session or
answer an incoming call.
You can also use the button to interrupt
system feedback and give a command at once.
PHONE END
While the voice recognition system is active,
press the
button to go back one step. Press
and hold the button for 5 seconds to quit
the voice recognition system at any time.
GETTING STARTED
The following procedures will help you get
started using the Bluetooth
® Hands-Free Phone
System with NISSAN Voice Recognition. For
additional command options, refer to “List of
voice commands” (P.4-56).
Choosing a language
You can interact with the Bluetooth ® Hands-
Free Phone System using English, Spanish or
French.
. Models with navigation system
For information on selecting a different
language, see “How to use the setup
button” (P.4-6).
. Models without navigation system
To change the language, perform the
following.
1) Press and hold the
button for more
than 5 seconds.
2) The system announces: “Press the
PHONE SEND ( ) button for the
hands-free phone system to enter the
speaker adaptation mode or press the
PHONE END (
) button to select a
different language.”
3) Push the button.
For information on speaker adaptation, see
“Speaker Adaptation (SA) mode” (P.4-59).
4) The system announces the current
language and gives you the option to
change the language to Spanish (in
Spanish) or French (in French). To
select the current language, press the
button. To select a different lan-
guage, tilt the tuning switch ( or
) up or down.
NOTE:
You must press the
button within 5
seconds to change the language.
5) If you decide not to change the lan-
guage, do not press either button. After
5 seconds, the VR session will end, and
the language will not be changed.
Connecting procedure
NOTE:
The connecting procedure must be per-
formed when the vehicle is stationary. If
the vehicle starts moving during the pro-
cedure, the procedure will be cancelled.
Condition: