NISSAN 2008 Altima Hybrid - Quick Reference Guide - Manual (Page 18)

4. Hold down both buttons until the indicator light on the HomeLink
ா flashes, changing
from a “slow blink” to a “rapidly flashing blink”. This could take up to 90 seconds.
When the indicator light flashes rapidly, both buttons may be released. The rapidly
flashing light indicates successful programming. To activate the garage door or other
programmed device, press and hold the programmed HomeLink
ா button - releasing
when the device begins to activate.
5. If the indicator light on the HomeLink
ா blinks rapidly for two seconds and then turns
solid, HomeLink
ா has picked up a “rolling code” garage door opener signal. You will
need to proceed with the next steps to train the HomeLink
ா to complete the
programming which may require a ladder and another person for convenience.
6. Press and release the “smart” or “learn” program button located on the garage door
opener’s motor to activate the “training mode”. This button is usually located near the
antenna wire that hangs down from the motor. If the wire originates from under a light
lens, you will need to remove the lens to access the program button.
NOTE: Once you have pressed and released the program button on the garage
door opener’s motor and the “training light” is lit, you have 30 seconds in which to
perform step 7. Use the help of a second person for convenience to assist when
performing this step.
7. Quickly within 30 seconds of pressing and releasing the garage door opener
program button, firmly press and release the HomeLink
ா button you’ve just pro-
grammed. Press and release the HomeLink
ா button up to three times to complete the
training.
8. Your HomeLink
ா button should now be programmed. (To program the remaining
HomeLink
ா buttons for additional door or gate openers, follow steps 2-8 only).
BLUETOOTH
ா HANDS-FREE PHONE SYSTEM (Without Navigation
System – if so equipped)
With an overhead microphone and sound
transmitted through the audio system speaker,
the Bluetooth
ா Hands-Free Phone System
utilizes Bluetooth
ா wireless technology and
voice recognition to provide hands-free cellu-
lar phone communication.
SYSTEM OPERATING TIPS
Ⅲ Close all windows. Surrounding noises
may interfere with system operation and
performance.
Ⅲ Press the
button on the steering wheel to activate voice recognition.
Ⅲ Wait for the tone before speaking.
Ⅲ Begin speaking a command within 5 seconds of the tone.
Ⅲ To go back to the previous command, say “Go back” or “Correction.”
Ⅲ To cancel a voice recognition session, simply wait 5 seconds, say “Cancel” or “Quit,” or
press the button.
Ⅲ To increase or decrease the volume of the voice prompts, push the + or – (volume)
control buttons on the steering wheel or turn the VOL (volume) knob on the audio system
while the system is responding.
16