beautypg.com

Lights – FORD 2002 F-150 v.1 User Manual

Page 71

background image

Replacing headlamp bulbs

1. Make sure that the headlamp control is in the OFF position.

2. Open the hood.

3. If equipped, remove headlamp
covers.

4. At the back of the headlamp, pull
clips rearward and up (about

3

4

inch) to release the headlamp
assembly.

5. Slide headlamp assembly forward
and off of guide ribs to expose the
back of the bulb and wiring
connector.

6. Disconnect the electrical
connector from the bulb by pulling
rearward.

7. Remove bulb retainer ring by
turning it counterclockwise, then
slide the ring off the plastic base.

8. Without turning, carefully pull
bulb assembly out of headlamp
assembly and replace.

Handle a halogen headlamp bulb carefully and keep out of
children’s reach. Grasp the bulb only by its plastic base and do

not touch the glass. The oil from your hand could cause the bulb to
break the next time the headlamps are operated.

9. Insert the glass end of the new bulb into the headlamp assembly.
When the grooves in the plastic base are aligned, push the bulb into the
lamp assembly until the plastic base contacts the rear of the lamp
assembly.

10. Install bulb retaining ring over the plastic base and lock the ring into
the socket by turning it clockwise until you feel a “stop.”

11. Connect the electrical connector into the plastic base until it “snaps.”

Lights

71